Fluid Cooler:
- Universal 6 row tube and fin all-aluminum heavy duty transmission cooler kit.
- Extend transmission life by helping prevent heat-related transmission failures.
- Perfect for high-stressed smaller and mid-size truck automatic transmissions.
- High efficiency turbulation and ultrasonically soldered for the best reliability.
- Dimensions: 0.75" x 7.5" x 12.5" with 3/8" hose barb inlets, GVW 18000 lbs.
Electric Fan:
- Universal 12 volt high performance 6" inch small electric cooling fan.
- Upgraded 90 watt motor draws 7.5 amps, producing over 513 CFM.
- Configured as an air puller to be on the inside and pull air through.
- Includes mounting bracket feet and complete install fin tie strap kit.
- Measures 7.2" x 7" x 2.4" thickness at center and slim 1.4" at edge.
Wiring Kit:
- Universal automotive electric fan 5-pin 40A relay switch harness kit.
- 14AWG size wire powers 1-2 cooling fans or 12 volt auto accessories.
- Maximum 30 amp continuous draw with 30A in-line fuse protection.
- A/C override or manual toggle switch wire built directly into harness.
- Installation instructions, wiring diagram and components included.
Hose Fitting:
- Universal AN in-line electric fan thermostat temperature switch kit.
- 1/8" inch NPT brass thread-in probe and dual pin disconnect switch.
- Preset to power fan or 12v accessory at the selected temperature.
- Anodized aluminum barbed straight push-on hose fitting adapters.
- Measures temp of any liquid including oil, water and coolant fluid.
NPT - American Standard Pipe Thread/Taper Guide:
NPT is not a measured size, but rather an industry call out size.
The NPT call out designation is not the true thread diameter inside or out.
|
PROBE SIZE |
ACTUAL OUTSIDE DIAMETER (INCHES) |
| 1/8" NPT | 0.405" (Approx. 13/32") |
| 1/4" NPT | 0.540" (Approx. 1/2") |
| 3/8" NPT | 0.675" (Approx. 5/8") |
| 1/2" NPT | 0.840" (Approx. 7/8") |
AN Fitting Size Guide:
The AN numbers refer to the tubing OD in sixteenths of an inch.
|
AN SIZE |
MALE THREAD SIZE |
TUBE SIZE (NOMINAL OD) | HOSE ID |
| 4AN | 7/16"-20 | 1/4" | 0.22" |
| 6AN | 9/16"-18 | 3/8" | 0.34" |
| 8AN | 3/4"-16 | 1/2" | 0.44" |
| 10AN | 7/8"-14 | 5/8" | 0.56" |
| 12AN | 1 1/16"-12 | 3/4" | 0.69" |
